Designed for light hand washing at a single basin, perfect for home use or installation in small offices.

Unlimited hot water for light hand washing at a single washroom basin.
Designed and assembled in the UK.
Stylish and compact ergonomic design.
Energy efficient – heats water instantly at point of use so no long pipe runs and no standing heat losses.
3.0 kW element.
Cost effective hot water for hand washing.
Integral inlet tap and swivel 200mm spray arm.
Optimised spray head to prevent splashing.
Durable easy to clean cover.
Simple to install and use.
Separate on/off and temperature and flow rate control.
No need to re-calibrate flow rate every usage.
Correct temperature instantly achieved every time.

Outer Casing
Easy clean high impact Polycarbonate/ABS

Heating Element
Copper-sheathed coil

Water Container
Glass reinforced nylon

Controls
On/Off:
HW30M Rotary switch

Temperature Selection:
HW30M and HW30A Rotary dial

Safety
Self re-setting thermal cut-out set at 60°C.
Manual resettable cut-out set at 90°C.
Pressure relief valve to prevent high-pressure build up.
Temperature stabilised – unit maintains consistent outlet temperature as water pressure conditions vary.

IP Rating
IPX4

Installation
The appliance must be installed in a frost free environment.
Wall mounted. Base assembly is secured to the wall by two fixing screws. Full fixing pack supplied.

Plumbing
Must be installed by a suitably qualified person.

Minimum water pressure 1.0 bar.
Maximum water pressure 6.0 bar.

Water Connection
Inlet 1 x 15mm compression.
Outlet 1 x push fit chrome plated brass spray arm 200mm (8″).

Electrical Connection
Installation must comply with current IEE regulations
This product should be connected to the fixed wiring of the property via a double pole fused spur with a minimum break capacity of 13 amps.

Approvals
CE, WRAS

Standard Warranty
1 year parts or replacement warranty.